Jewelry customization: co nail embedding processing technology

The entire process of jewelry customization with common nails (also known as double nails), this type of nail starting method is to sort the edges in a row shape, and the middle of the edges is only a common nail with small spacing.

Jewelry customization

Li Xin recommends the common nail embedding processing technology:

1. Fixed fixed metal bracket

Jewelry processing should use a welding machine to heat up the lacquer seal, place the metal holder on a wooden stick with the lacquer seal on top, and lay it flat. The metal holder should be firmly adhered, and the edges should be sealed to prevent deformation. If there is a lacquer seal overflowing from the inlay, use a sewing needle to empty it before embedding.

Jewelry customization

2. Renovation and inlay

The silver jewelry processing application is suitable for the size of the wave needle trimming and inlay, and the top of the wave needle is usually coated with leather like mud to facilitate stone cutting. In addition, the inlay should be turned straight to prevent the edges from being skewed, otherwise the lower stone is very prone to being skewed. The deep layer of the inlay should consider that the surface of the inlay stone is level with the surface metal after the stone is lowered. If it is higher than the metal surface, the inlay stone is not easy to be strong.

Jewelry customization

3. Placing stones

Can use a top grade sewing needle dipped in leather like mud to stick the crystal stone (crystal cabinet countertop) into the inlay mouth, and adjust the inlay stone correctly.

4. Rock pressure

Use a flat machine needle at the top to vertically divide the crystal on the cabinet top and clamp the crystal tightly. If the crystal is tilted, do not use specialized tools such as medical tweezers or machine needles to clamp the crystal tightly and then adhere to the inlay mouth. This makes it difficult to remove the inlay stone. After pressing the stone, the crystal cabinet top will be at the same height, and the crystal stones will be arranged neatly.

5. Shovel nails

(1) Advance preparation of steel shovel

Due to the small size of the individual who needs to lift the nail, it is necessary to grind the sewing needle on a diamond, and then use the sharpening technique to grind the top of the sewing needle into a small shovel with a relative angle of 90 °. Additionally, the steel shovel must be held in an appropriate posture.

(2) Nail lifting

For co nailing, there are two types of nailing methods, namely the common nailing method between two stone inlays and the nailing method at the corner of the edge stone inlay. The first method is to sort the orientation along the inlay opening, and use a steel shovel to shovel at 30 ° on both sides of the inlay stones. Slowly dig deep and lift to 60 °, and then lift a copper sheet. Then, use a steel shovel to extend both sides of the copper sheet and shovel it into a small metal shovel.

6. Shovel edge

Use a steel shovel to insert the shovel along the embedded edge, and use the method of pushing while picking to make the metal edge on the side of the stone row continuously shine.

7. Draw the nail round

Apply suction beads that are suitable for the specifications to round the top of the nail. You can choose to use a gold sewing needle to drill a concave hole at the top of the machine needle to create a self made suction bead. When using a self made suction bead to top the nail, it is best to use the suction bead to touch it with some leather mud, which can reduce the heat at the suction nail and make the nail look brighter after suction.

The above is the content collected by Yichang Lixin Jewelry Technology Co., Ltd. If you need to develop it, please contact us.

News Center

Jewelry customization: co nail embedding processing technology